Arctic Spa Summit Manuel de service télécharger pdf (Page 26)

Onzen Technical Guide North American Topside

1.17 O F A Q

Onzen Questions

Question 1: How do I know if the Onzen system is working?

Conduct a “Sanitizer Production test” (Also known as a Smoke test).

is procedure activates the Onzen System while de-activating the ltration pump so you can see the mist of gas

bubbles produced by the Onzen System.

Question 2: What should I do if it fails the “Sanitizer Production test”?

First, conrm you have the correct concentration of salt in the water “using sodium chloride test strips”. en, start

maintaining your water manually using “Boost” granular chlorine to sanitize and Adjust Up/Adjust Down to balance

pH. Continue to do this daily until the system is repaired by an authorized service technician.

* Keep enjoying your hot tub!

Question 3: How do I know if the Ozone system is working?

Conduct an “Ozone Production test”.

is procedure activates the Ozone System through activating a ltration cycle so you can conrm:

· at a blue light is omiing from the Onzen Generator.

· ere are bubbles and a ow of water coming from the Onzen Output Electrode located in the spa foot well.

Question 4: What should I do if no bubbles are sighted from the spa drain when the Ozone

system test is conducted?

If no bubbles sighted during the Ozone System test, this could indicate a blockage in the Onzen plumbing, Cycle

PUMP 1 on HIGH SPEED repeatedly. If this does not work, dealer service may be required.

Refer Conducting An Ozone Production Test

Question 5: What should I do if the chlorine levels are too high?

Turn the Onzen Output down (decrease “CP” seings).

Unless you added granular chlorine or shock to the water high chlorine levels mean the system is staying on too long

for your circumstances. It may take a day or two for levels to normalize, or you can speed this process up by using a

chlorine neutralizer, such as “X-it”.

Question 6: What should I do if the pH keeps increasing?

Conrm that your Total Alkalinity is at the recommended level and reduce it manually with ‘Adjust Down’.

is is normal; all spa salt systems cause pH to increase.

Question 7: Will the salted water damage my lawn?

is is very unlikely.

e recommended concentration of salt is used is approximately 10% of the concentration of sea water.

Question 8: Why is my water bright yellow, or bright green, or a rusty colour suddenly?

is can happen if the pH gets too high.

Lower the pH using ‘Adjust Down’. High pH is a sign that the Onzen Output may be turned up too high, so you may

need to adjust the Onzen Output Aer balancing the pH and adjusting the Onzen Output wait about 48 hours. If the

colour of the water does not normalize you may need to replace the water.

1 2 ... 21 22 23 24 25 26 27 28 29

Pas de commentaire

Arctic Spa Summit Manuel de service Page 26