Arctic Spa Summit Manuel de service télécharger pdf (Page 16)

Onzen Technical Guide North American Topside

Steps to Establish Chemically Balanced Water With Onzen

Step 4. Add Salt to Spa Water & Test TA / pH

(a) Slowly pour the dissolved salt from the pail into the spa water.

(b) Run pumps for 5 minutes to help mix salt blend through.

(d) en test and adjust Total Alkalinity level accordingly.

(e) en test and adjust pH level accordingly.

Refer to steps 3 and 4 for correct TA/pH levels.

Step 5. Repeat Step 3 & 4

Repeat steps 5 and 6, ensuring all sub steps are carried out accordingly.

Step 6. Repeat Step 3 & 4

Repeat steps 5 and 6, ensuring all sub steps are carried out accordingly.

Step 7. Test Sodium Chloride Level

You will now need to test sodium chloride levels.

Refer ‘Using Sodium Chloride Test Strips’ for details.

If sodium chloride levels are low, dissolve 1/2 lb (225 Grams) of salt

(using cup provided) into hot water. Pour the dissolved salt into the

spa water. Test sodium chloride level.

Repeat until required sodium chloride level is reached:

Onzen Version Minimum Maximum

Version 7 2000 ppm 3000 ppm

Version 8 1200 ppm 1500 ppm

Note: e Arctic Spas Onzen Salt Chart in this guide provides the

estimated impact of adding ½ lb (225Grams) of salt to

your spa.

Note: For start up it is recommended to strive for the minimum

salt dosage. Once a Sodium Chloride reading has been taken

and the minimum salt dosage achieved, it can be increased

slightly to accommodate spa usage and bather load, if

increasing the Onzen run time does not adequately increase

the Chlorine Residual. Having the minimum amount of salt

concentration unless the Onzen system is unable to maintain

the proper Chlorine Residual, will reduce potential corrosion

and increase the life of the Onzen Output Electrode.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Pas de commentaire

Arctic Spa Summit Manuel de service Page 16